Flush Trim Router Bit with Carbide Inserts

Description: 2 size: 1-3/16" diameter by 2-1/8" cutting length and 1-3/16" diameter by 1-3/16" cutting length. This is the last Flush trim router bit you'll ever buy. Straight blade bits and even spiral/compression router bits will all eventually need to be sharpened or replaced. This bit, with it's carbide inserts, allows you to loosen the set screw and rotate insert 90 degrees to get another razor sharp edge. No need to replace the router bit. The carbide inserts are 4 sided, allowing you to get 4x's the life of other router bits. If you break an insert, just remove screw and replace the damaged insert (you don't have to buy a new bit). With bearings on top and bottom, you can use a template on top or bottom of your workpiece. These bits are pricey but are worth it and will last a lifetime, bringing the enjoyment back to woodworking. Also, I'm not just a seller but have my own woodworking shop. I had an order for 75 Mesquite European plaques (3pc) and used this bit for all my template work. Never rotated or changed out any of the inserts while completing this order. Mesquite is one of the hardest woods out there and I still had no problems. It would of not been that way with a standard, or even premium, flush trim bit. CAUTION - RECOMMENDED FOR ROUTER TABLE USE ONLY, HANDHELD ROUTER USE IS NOT ADVISED! Also, replacement carbide inserts available, sold in quantities of (10). If you select quantity of 1, you will receive (10) inserts. All bits come with a T15 tool to rotate or replace the carbide inserts.

Price: 29.99 USD

Location: Victoria, Texas

End Time: 2025-01-16T18:56:32.000Z

Shipping Cost: 4.95 USD